This 3D model is the key to unlocking the full potential of your workspace. With its thoughtfully crafted design, the filament guide, combined with replacing the power cable with an angled plug, allows the Creality 1K printer to sit as close to the wall as if it were part of it. Like a perfectly fitting puzzle piece, this solution minimizes the printer’s footprint and brings a sleek, modern look to your workshop.

Installation is simple and intuitive, utilizing two factory-prepared holes located on the back of the printer, just below the filament sensor. No modifications or complex tools are required—just two M3 screws to create a seamless and functional setup.

This design lets you virtually “anchor” your printer to the wall while improving workspace organization and eliminating unnecessary clutter. It’s a solution that blends aesthetics with practicality, helping you make the most of every inch of your creative environment.

Thank you for your feedback - your feedback means a lot to me! I hope you consider giving this project a five-star rating! 😊