Just got some purple and orange filament and decided to try and create a Purple People Eater based on the original 1958 song. Sized small for my Monoprice Mini.

Print Settings

Printer Brand:

Monoprice

Printer:

Rafts:

Yes

Supports:

Resolution:

.1 mm

Infill:

Notes:

The Head, Short Shorts, Teeth, Eyeball and Pupil won't need supports, but the rest will.

The eyeball and pupil are a tight fit. I had to trim the bottom edge a bit with an exacto knife. I used a small hammer and protective piece of mat to tap into place. Maybe you can adjust it better in whatever modeling software you have before slicing. The arms, nose and horn fit nicely and the rest is super glued in place. I used a 1/8 inch hole punch to make the polka dots for the short shorts, but the dots are slightly recessed if you want to just paint them in.

Category: Creatures