Remixed configurable abacus designed for a single (albeit long) print. 

Very annoying print in my opinion. The tiny adhesion of the beads fails 90% of the time. Had to print with a raft to make it only fail 60% of the attempts. Between the 12hr print and the repeated failures made me nearly give up a lot of the time. When it did finish it felt like hours to remove all the supports and raft, and even then it didn't clean up very well. 

Probably worked too long on getting it to print correctly and reliably, when presented to my wife's blind student his immediate comment was “It's too loud” which had never occurred to me. Has all the dots and bars to make it an applicable abacus and a full frame.

Ended up scrapping the entire project and starting over from scratch. But, I put too much work into it to just throw it away. Maybe someone could find a use for it.