This is a variation of another case I remodeled, but new.  

The newest bits are that the model feet are now meant to accommodate a sideways tilt, allowing the cables to run to the rear, instead of running out the sides and causing a wider footprint.  Most will require mods to the configuration to allow screen rotation and touch rotation.  

Assembly only requires 4 threaded inserts (m3x4x5) and 4 m3x25 SH bolts.  Only gotcha with most of these is that the layout of the ports vary a bit, so the area where the ports come out may need to be modified to align with your ports. 

The reclining foot model will require the upper and lower feet, the standing foot will need 2 of the same feet.