Summary

This is my Remix for the indicator holder.

I made two versions; one to hold a standard 1 inch indicator and one to hold a 10mm import indicator. The Import indicator has a smaller mounting shaft so; so height and hole size are different.
Since it can be hard to print and maintain a press fit I elected to go with a Thumb Screw Clamp.

Also found that a narrower version with just to magnets wasn’t stable enough so widened one end and went to a pattern of three magnets. I over sized the holes for the magnets and used Epoxy to bond in place.

Note: the two Thingiverse views (blue parts on build table) are shown in the wrong orientation. Long side shown in views should be against the build table. No supports, medium build setting, aprox about 50+ minutes to print.