This model includes a replica of the frame around the coin eject buttons for a WMS/Bally style pinball coin door. The exact door this fits is the one sold by Virtuapin, but this may fit other coin doors as well.

Additional Hardware

• (2) 3x4x5mm heatset inserts
• (4) M3 x 8mm
• (4) M3 washer
• (4) M5 washer
• 2.7mm RGB LED strip (the tiny ones)

Assembly/Installation

1. Glue the coin return flap in place
2. Insert 2 heatsets into Coin Insert Frame
3. Cut LED strips to fit (I found about 26 to 28 LEDs was right)
4. Solder power and data wires onto LEDs
5. Pass wires through holes in the door where screws are not used (both frames only use 2 screws but there are 4 screw holes)
6. When mounting each screw gets an M3 washer and M5 washer