Single Pegboard Socket Holders
retro_forge
Найти похожую с ИИ
Профиль печати(0)
Файл модели(0)
0
1
0
Опубликовано:2026-03-17 23:12:19
0
0
010Описание
Теги
Источник модели
Отзывы(0)
Single socket holder for use in 1/4 pegboard. Included 1/2 inch, 1/4 inch, and 3/8 inch with and without a stabilizer.
This was built to minimize the design and to allow a single socket to consume a single pegboard hole for use with individually purchased sockets so that they could fill in smaller areas or allow for custom configurations on the board.
One downfall, the design allows the holder to rotate which may be problematic for some, so a stabilizer was added to keep it from rotating, but the addition of the stabilizer does mean that it will consume two holes in the pegboard.
Print Settings
Printer Brand:
Monoprice
Printer:
Maker Select Plus
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.1
Infill:
30
Filament: Monoprice PLA+ Gray
Notes:
Recommend rotating to set the socket portion on the bed. Also the supports should be customized to ensure that it stays out from in between the two sides of the socket otherwise it may be difficult to remove.
Теги
Источник модели
Оригинальная ссылка: Посмотреть детали
CC-BY