This is a handy little wrench for removing vehicle antennas before going through a car wash.

I designed this for my 2015 Silverado, but it should work on any vehicle with a threaded antenna that uses a 10mm nut. That's 10mm flat to flat, not thread diameter... If you use a 10mm wrench to remove your antenna, this tool should work for you.

I printed this with 100% infill and it only took about 1/2 hour. I recommend 100% infill for strength, but it will probably work fine for the most part with a minimum infill of 20%.

The notch opening of the tool is intended for slipping on the antenna itself, then dropping it to the nut to be loosened. I did this for my wife who is vertically challenged and unable to reach a box end wrench over the tip of the antenna.

Print Settings

Printer Brand:

Anycubic

Printer:

Rafts:

No

Supports:

Resolution:

.2

Infill:

Filament: Amazon Basic's PLA Orange

Notes:

Category: Automotive