LED Dimmer Mount
olivecab9
Найти похожую с ИИ
Профиль печати(0)
Файл модели(0)
0
0
0
Опубликовано:2026-01-16 10:08:17
0
0
000Описание
Теги
Источник модели
Отзывы(0)
Replacement backplate for an inexpensive LED dimmer control (see link) that allows it to be easily mounted to the bottom of a desk. Great for use with a LED strip for a keyboard shelf light. Simply unscrew the back and replace with this print.
Or you could just use some double sided tape.
https://www.ebay.com/itm/264079937641
Print Settings
Printer:
Sidewinder X1
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Notes:
I printed this with the internal side up as that's where all the fine detail is, allowing it to interface properly with the LED dimmer. This does mean some supports are required but since it needn't look pretty on the back cleanup is no big deal. I found it useful to block support under the screw holes (using Cura) to reduce cleanup further.
If you have trouble assembling, the screw holes on the back (6 mm or 1/4") as well as the alignment ones on the front (4 mm or 5/32"), then they might benefit from being drilled out for greater accuracy.
Custom Section
Category: HouseholdТеги
Источник модели
Оригинальная ссылка: Посмотреть детали
CC-BY