It is printed with PLA in default settings with supports in 0.2mm height.

Edit 2025-09-09: I added version 2, where was reworked models for screw drivers, tweezers and screw case and was added model for SpeedyBee adapter and flux. This rework is done by using on the fied and testing it in several situations.

How to setup this toolbox:

• Plate 1 - Solder holder:
  • omnifixo - toolbox - solder: this is a main body for the solder tools and omnifixo holders and magnets - you need also 4 magnets 5x3mm
  • omnifixo - toolbox - solder - bottom_plate: this is a bottom plate for solder holder - needs to be glued to the main body
  • omnifixo - toolbox - solder - side_coverl: this is a side cover for solder holder
• Plate 2 - Screw drivers:
  • omnifixo - toolbox - screwdrivers: this is a main body for the screwdrivers - you need also 8 magnets 5x3mm
  • omnifixo - toolbox - screwdrivers - bits: this is a bit holder for the screwdrivers - for holding this part you can use a filament
• Plate 3 - Tweezers and pliers:
  • omnifixo - toolbox - tweezers: this is a main body for the tweezer's holder - you need also 8 magnets 5x3mm
• Plate 4 - Srew case:
  • omnifixo - toolbox - screw case: this is a main body for the screw case - you need also 8 magnets 5x3mm and magnetic foil 200x100x1mm
  • omnifixo - toolbox - screw divider: this is a screw divider
• Plate 5 - SpeedyBee Adapter:
  • omnifixo - toolbox - sb adapter: this is a main body for the SpeedyBee adapter V3, it's cable and TBS Flux for soldering - you need also 8 magnets 5x3mm

What tools and material I use in case:

• 36x neodymium magnets
• 1x magnetic foil 200x100x1mm
• 1x Sequre SI012 Pro 65W Kit (B2)
• 1x Sequre TS-I spare tip
• 1x Sequre stand for soldering pen
• 1x Tip cleaner
• 1x FlyfishRC Screwdriver 7in1
• 1x set of Hex wrench
• 1x Tweezers NB-ESD14
• 1x some tweezers with bended tip
• 1x filament pliers BEST-109
• 1x SpeedyBee Adapter V3
• 1x TBS Flux