Drawer Divider
Jason3d
Найти похожую с ИИ
Профиль печати(0)
Файл модели(0)
0
0
0
Опубликовано:2026-02-02 04:18:41
0
0
000Описание
Источник модели
Отзывы(0)
Designed for the drawers in the 8 1/2" D x 7 1/4" W x 6 7/8" H Sterilite 3 drawer organizer (#2073). Provides for 4 sections, each appox. 1.25" wide.
I did not put a crosspiece at the front, as I wanted the drawer contents visable.
Print Settings
Printer:
Klic N Print 3D (KNP3D)
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
15%
Filament:
other PLAWhite
Notes:
I printed with a 3mm brim to ensure adhesion. I decided to leave the brim in place for a little more stability, except at the very back (the horizontal piece) so that it would sit against the back of the drawer. I attached it to the back of the drawer with a couple of small double stick foam squares. That keeps it from wiggling around in the drawer. I choose not to glue it to the bottom, as the drawers themselves have a little warp to them.
Designed in Tinkercad https://www.tinkercad.com/things/kEuMWfuFB4s-drawer-divider
Category: OrganizationИсточник модели
Оригинальная ссылка: Посмотреть детали
CC-BY-SA