Description

A friend asked for a 3d print to lock up a pint of ice cream for their daughter. I didn't find any good models that looked easy to print so I created this one. I tested it on Ben & Jerry's, but it should be flexible enough for most pints. Including the scad if anyone wants to tweak it for other sizes.

Print Instructions

Padlock not included
No supports
No raft
Tested in PETG, 0.4mm nozzle, “0.2mm speed”, Mk4 (see .3mf)
Note: It might be a bit big for the Prusa Mini, looks like it will barely fit.
 

I used a modifier in PrusaSlicer to remove top/bottom layers in the middle of the top for looks.