Print Instructions

Its only a 3 hour print on slow settings but that could easily be taken down to and hour and a half.

Only uses 24 grams of pla.   

Wind Sock: Set your line width to .4 mm. Can't be printed in vase mode because there are        holes for the screws.

   Wind Sock Stand: Use 4 perimeters and 15% infill.

   Hardware-less Connecter: Uses built in pins rather than screws.

   Hardware Using Connector: Uses two short M2 screws. (You don't need to print both                  connectors, just one.)

Rc Plane RC plane Airport Airfield Runway