Spool mounting bracket for 3030 extruder
Elminuna
Найти похожую с ИИ
Профиль печати(0)
Файл модели(0)
0
0
0
Опубликовано:2026-02-22 12:20:11
0
0
000Описание
Источник модели
Отзывы(0)
I used the original for the top of my Haribo 3030 but made some feet so I could mount it on an offcut of 3030 to use with another printer, I then made a version with integral feet and pushfit bearings that can be secured using M6 cap screws left over from my printer build but actually they are a tight push fit so may not need the screws, I also ordered some flange bearings so the reel will not touch the inside of the support but they've yet to arrive
Print Settings
Printer:
Prusa Clone/Haribo 3030
Rafts:
No
Supports:
No
Resolution:
0.3
Infill:
20 - 30%
Notes:
Printed in PETG but you can use PLA or ABS I suppose
Secure the bearings
I ran a M6 tap through the holes for the bearings, one of those with the drill at the beginning using my cordless drill and doing it slowly. Then add a 12 - 15mm M6 cap screw to secure the bearing in place, don't over tighten though as the material isn't very thick.
CAD software used
onShape
Источник модели
Оригинальная ссылка: Посмотреть детали
CC-BY