This is a lightweight cable guide designed to lift and route cables above the floor or desk surface. The model allows you to pass a cable through it to keep it suspended or fixed along a path before it reaches a proper holder or clip.

It’s useful for:
– Preventing cables from dragging or tangling on the floor
– Creating clean, elevated cable paths
– Preparing cable entry into desks, devices or holders

Can be attached using:
– Screws
– Double-sided tape
– Adhesive pads
– Mounting strips

The internal diameter is suitable for standard charging or peripheral cables and can be scaled as needed.

Recommended print settings:
– Material: PLA or PETG
– Layer height: 0.2 mm
– Supports: usually not needed
– 3+ walls/perimeters for durability

Simple and functional, ideal for clean cable management.