When my E-bikes cords started protruding from the factory supplied cord wrap, I had the idea that I could make short-ish sections of something similar and use these shorter segments for wrapping up wire found throughout the house.

Voila, the custom spiral TPU cord wrapper thank's to Fusion 360 and a little fun designing.

Creality

Ender 3

No

No

200

38

Temp: 228
Speed: < slower than PLA

If I'm not mistaken, I had to decrease the size of the stl with the slicer, so that I could maximize the length dimension and it would still fit on the print bed at an angle. Sorry, my BAD, Ender 3 folks. But, a couple of clicks of the mouse and it will be just right for your print bed size.