Thickness gauge/swatch
KatherineWilkerson
Найти похожую с ИИ
Профиль печати(0)
Файл модели(0)
0
0
0
Опубликовано:2025-12-31 22:01:51
0
0
000Описание
Теги
Источник модели
Отзывы(0)
A very simple thickness swatch with clear labelling and a hole gauge. The hole has the same diameter as and is offset by the thickness of the swatch (eg: the 3mm thick swatch has a 3mm diameter hole who's centre is offset 3mm from the edge).
This doesn't have any fancy case and is instead held together by a single M4 18mm + nut for the 1-5 set.
You can use the customizer to change the range of sizes created by altering min_finger_thickness and max_finger_thickness. It should handle most ranges of thicknesses pretty well but if you go above ~12 you might want to rework the label placement or optimize for width.
Print Settings
Printer Brand:
Dremel Digilab
Printer:
3D20
Rafts:
No
Supports:
No
Resolution:
100
Infill:
30
Filament:
Dremel PLA
Notes:
I've found printing with the highest resolution possible works best. Even then, I like to give the holes a quick pass with an appropriately sized drill bit to ensure dimensional accuracy.
Теги
Источник модели
Оригинальная ссылка: Посмотреть детали
CC-BY