🚨NEW (and better) DESIGN 🚨

I released the new design of this clock here!

💻👾CIRCUIT DIAGRAM and FIRMWARE

 https://github.com/telepath9/TM1637Clock

🟢 The clock has two modes:

1. ONLINE: the first connection to wifi is mandatory in order to get the time from NTP servers;
2. OFFLINE: once it retrieves the time from NTP servers, it stores it in the RTC module. Now wifi is optional.

🟠 How to print

• Layer width: 0.4
• Layer height: 0.3
• Perimeters (case): 3
• Supports (case): yes
• Perimeters (lid): 1
• Supports (lid): no

⚙ What you need

• Wemos D1 MINI (mine is V3.0.0) or Wemos S2 mini
• TM1637 module   https://a.aliexpress.com/_EuPY34F
• (optional) RTC module DS1307 
• x9 M2.5x6 screws and x3 M2.5 nuts
• (optional) 12mm waterproof button
• A small piece of breadboard
• Wires

⚪Other

• Nuts should be embedded in the case, so remember to add a pause on your slicer, at the right layer (91 if you print with 0.3) , in order to put them in their spots!
• Because D1 mini has only 1 GND pin, and we need at least 2 GND pins, the solution i came up was to cut a piece of breadboard, drilling it, solder 3 headers and wiring it to the D1 mini GND, in order to have a GND expander.
• About TM1637 module: you can mount it with 3 or 2 screws, because the 4th one isn't so reachable