This is a seat for a Snapmaker toolheads can be set on a frenbch cleat.

Tested with the following toolheads:

• CNC
• Laser 1600mW
• (should work for the 3D Printing tool, but it currently is in duty)

Should not be printed in PLA, because these toolheads are quite heavy.

Prints very clean on the diagonal cut on the right lower edge, where the business part toolhead sticks out. This way printing only needs a little suport under the lowest “bridge” (last photo), all other overhangs are on a 45 degree angle to the printbed.

The print you see in the photos is done using a 0.8mm nozzle for sturdiness in the workshop, where esthetics do not matter.
Prints safer with a brim since the rather larg part sticks out into the air.

Update: Introduced a hat (cap) to protect the connector socket from dust.