Has been printed and tested and works. Added version 2 now which adds some reinforcement around the bearings. There was a report of the thinner section around the bearing splitting after some time. This was with ASA mine is printed in PLA + and have not seen this issue yet, but adding the extra material should fix the issue.

This is a new carriage with provisions to mount a Orbitor extruder to the CR-200B. The wire channel has been moved back a bit allow the Orbitor mounting screw. All of the mounting holes such as hotend, hotend fan, original cover mounting holes and Oribiter are intended to use 3x3x5 mm brass heat inserts. You will need 2x LM8LUU bearings or remove the ones from the original carriage and use them.

As stated not printed yet needs tested.

FlashForge

Creator Pro

No

No

35