Raspberry Pi gaming case. Thought this would look really cool so I decided to try and make a raspberry pi look like a gaming PC and I am happy with what I have come up with. It uses 3 of GeekPi's RGB 40mm fans that run off of the 5v and 3v rails on the board. These fans are almost silent and do incredible cooling especially when you have 3 of them. To hold it all together I used a assortment of M2.5 standoffs from YuhTech and used their 120pcs black nylon set. For the side panel I used an A5 sheet of clear acrylic that I cut down to size and drilled holes in for the screws to hold it in place.

All parts have been optimized for 3D printing and no supports are needed. This was printed in black PLA at a layer height of 0.2mm.

I have designed this to also be compatible with raspberry pi 3s as well but as I do not have one my self I have made it so the back IO holder is removable / easy to modify for the raspberry pi 3.

Links to products I have used:
https://www.amazon.co.uk/s?k=A5+clear+acrylic&i=kitchen&ref=nb_sb_noss_2

https://www.amazon.co.uk/s?i=aps&k=geeekpi%2040mm%20fans%20RGB&ref=nb_sb_noss&url=search-alias%3Daps

https://www.amazon.co.uk/gp/product/B07QDQBPP6/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&psc=1

This still will be improved as at the moment you need quite a few screws and standoffs to put it together and I hope to make it fully 3D printable with no screws in the future but for now here it is.

I also have a very small video that shows how it all goes together on my Instagram, I'm not sure how helpful it is but check it out,
insta: 3d_and_robotics

Creality

Ender 3

No

No

0.2

50%

I would suggest to use PLA as the base warps very easily and even warped a bit with PLA and I've heard ABS warps quite easily.