This Ender 5 Tool Holder Remix is based on the Ender 5 Tool holder by TrigoKlei on Thingiverse: https://www.thingiverse.com/thing:3655629

It includes one extra hole for a nozzle wrench due to some nozzles using a different size standard than the original Ender wrench. The needle hole has been made a little wider to prevent it from getting blocked when it prints, and the USB hole has been made a little shallower to allow the USB to stick out the bottom, so that it can be pushed out or pulled out. The holes have also been adjusted slightly, reducing some gaps to save filament. The arms are also better designed to help it snap into place and maintain good friction.

Printing: no supports, 15-20% infill, PLA, no brim

Mounting: Insert rigid side into channel, push opposite side with thinner armature toward the corner of the channel post, push hard to snap into place being careful to hold the printer.

Position adjustment: Use bashing equipment (hammer-like instrument) to lightly tap the tool holder into place. It's recommended to put the spatula in place while moving it up or down in order to know how far down to move it.