I wanted a riser for my K1C which would allow me to secure the corners using the M3x8 screws which already support the printer lid.

I modified the Creality K1/K1C Hinged Riser corners to allow me to do this.

Features

• No supports required
• No bed adhesion required (i.e., autobrim, raft)

Additional parts required

• Four M3x8 screws which are already with the printer to support the lid

My print configuration

• Material: PLA
• Infill: 15%
• Infill Pattern: Gyroid
• Supports: No
• Brim/ Raft: None

The hole in each corner may need to be made slightly larger in post processing to allow some extra wiggle room to avoid cross-threading the screws into the holes.

Enhancements to the original design

• No additional hardware needs to be purchased. It is already installed in the printer,