After switching over to reverse props my stack got covered in grass (instead of my cam) so I went and designed a stack cover.

It slides over the standoff mounts (15mm in my case) but you can customize that.
There are also cutouts for the arms/escs and on the rear for the lipo cable.
My USB Port is obstructed by one of the standoffs so I didn't bother with a cutout for it but feel free to remix and add one.

Printed in Semiflex/TPU which allows for some flexibility and tolerances with the walls.
It might be possible to print it in ABS/PLA but you may have to adjust it a little for that.

It pretty much worked out as I hoped on the first try so I didn't tweak it much further after the first print.

Malyan M150

No

No

0.2

100%

Infill shouldn't matter much but make sure to print in TPU/Semiflex or Ninjaflex.