This is my take on EBB36 canbus board holder for Voron Stealthburner. I have taken the model from Kotvic (Thank you!) and pretty much redesigned it to address some issues I have found with the original model:

1. Heat inserts holes were too small (4.5mm) - changed to 4.7mm.
2. Heat inserts for the clamp were pushing plastic onto the corrugated hose groove making the hose and clamp attachment difficult - fixed by removing the plastic there.
3. Raised the EBB36 mount a bit to give more space to the board rear.
4. M3 screw holes (thread and head) were a bit small, making the assembly more difficult.
5. Due to 3, I had to move the corrugated hose groove up to align with the EBB36 data port.

Print with standard Voron settings.

Unfortunately, If you need a different corrugated hose diameter, there are no user parameters to change in the attached CAD. However, CAD is attached. 

Required hardware:

6x M3x8mm BHCS or SHCS screw

4x M3 Threaded Insert (M3x5x4, Voron standard)

This is the hose I used (was the quickest shipping): RANIT 3M/9.8Ft Long Corrugated Tube Black Plastic 10Mm x 7Mm Flexible Corrugated Conduit Pipe Hose Tubing https://a.co/d/iro3RRV (Not an affiliate link)