A simple hook that can be screwed into your desk to help manage cables.

I liked the shape of https://www.printables.com/model/217285-under-desk-cable-management-hook, but that one is a little chonky and way, way larger than I needed. This model was made from scratch to be much smaller but still hold a bunch of cables.

Holes are for small flat-head screws. The diameter of the ones I used were about 1/8in or ~3mm.

Model is approximately 75mm long, 15mm tall, 11mm wide.

Printing Settings

• Material: any (tested with PLA)
• Infill: 15% is fine
• Perimeters: 2 is fine
• Layer height: whatever
• Supports: None

For reference here is a size comparison of nzalog's hook and this one: