Use this to stop button wiggle and mis-clicks by generating a friction fit circular button guide/bezel/trim. You can set mount diameter, mount offset, bezel diameter, bezel thickness, button recess on the trim, button diameter at the bezel and mount sides of the model (for buttons that are conical shaped, like on the Anet A8).

Works in the customizer!

Example values for my Anet A8. Mine is one with the newer dimensions, buttons are 6.1 mm and the housing button holes are 7.8 mm.

I made this because I liked the look of the Anet A8 button guides for the older dimensions, but there wasn't anything that looked like this for the newer dimensions. And of course to stop my buttons from wiggling all around in the housing holes when I pressed them. Should be useful for any enclosures with loose buttons.

I'd recommend printing with z-seam alignment set to shortest.

Anet A8

No

No

0.1

20%