Two simple brackets that securely mount your Raspberry Pi 2 (with case) on top of your Prusa i3 MK2 power supply unit (PSU). This works well for an OctoPi setup. I'm using a generic 61mm x 28mm RasPi2 plastic case and these brackets are sized to fit it.

I had to slide the back bracket (the one closest to the Prusa frame) forward to allow for the RasPi power cord, which made it not line up with the inside PSU vents. The back bracket, therefore, doesn't have a nipple on that leg.

The front bracket (the one furthest away from the Prusa frame) has nipples on both legs which line up with the vents in the PSU and clip the bracket in place.

I mounted my RasPi camera on the front right of the heatbed using this thing from Exclusive.

By mounting the RasPi on the PSU side of the Prusa, a 24" (61cm) camera cable is the perfect length.

Prusa i3 MK2

No

No

200um

10% density, Zig Zag pattern (Cura 2.4)

Printed with PLA using a 205C hotend & 60C bed. Printed flat, took about 48 minutes for each bracket.