I enjoyed some of the other deck displays that hold a card deck against the wall but I wanted one that made it look as though the deck was floating a little away from the wall. So I designed this.

I used 3lb command strips to hold the mount against the wall.

For slicing I'm using Cura 4.6.1 and the experimental tree supports have been working fantastic. YMMV so use whatever support structure works for you. The "arms" will definitely need it. Be careful removing the supports so that the arms don't get broken.

I made a second design in an attempt to save some plastic and potential print time but it ended up being about the same after factoring everything in. I included the second design anyhow. If you like that one better go for it. The center sections shouldn't need supports. Only the "arms" that hold the deck in place.

Wanhao

Wanhao Duplicator i3 Plus

No

Yes

0.2

20%