The case feeder for the XL650/750 model shows a support arm (Dillon Part 21326) that they state is included with their reloaders -- but oftentimes (as in mine and others) this part is missing. To make it more frustrating, they actually don't sell the part on their website either as a replacement.

So...I made my own. Simple design, nests the case feeder support tube and secures with a 6mm or 1/4 bolt and it cradles the clear casefeed tube on the front with a friction fit that can be removed as needed.

This will fit on an 8" print bed by arranging the piece at an angle.

Yes

No

0.2

25

I used 1.5mm walls since all side walls are 3mm thick -- this will give it the best rigidity. You may tune as you like.