Summary

Just a simple remix to bring the light pipes in from above the LEDs on the Pi3. Also enlarged the holes to 1.8mm so clear 1.75mm PLA can be used for the light pipes. I also left the horizontal holes for lower profile designs, but enlarged them to 1.8mm as well.

I'll need to print it out and check the hole size, they're probably going to be too small as is.

01/13 - Added a version with 1.9mm holes. This one fits much better. I did round out the holes using a pointed pick, I just worked it in with a bit of a twist to round out the slight deformity of the first layer and my 1.75mm filament slid in nicely. Stuck it against a Pi2 only to find out that the LEDs are on the other side of the board. My only Pi3 is in a RetroPie station I made for the nephews so I can't test fit this onto a board until Amazon can get me another one.