Spiral Fidget

I like the look of the new spiral fidgets but it takes two hands to play with them. Sometimes you only have one hand. So I made one with the inside captured. Still gives the amazement of the center going through the outside part but doesn’t fall apart.

I made three sizes. If you try to scale them up or down I am not sure how well it will work because you will be changing the tolerances.
I like the large one the best because the weight makes it slide faster but the middle size seems a little more comfortable.
The large one is the first one I made and I forgot to chamfer the edge so it is a Little sharp but not cutting. I will try to get a new file done one of these days when I get time.

I printed with no supports of any kind but make sure you have a clean bed for good adhesion.

I used the Spiral Fidget Cutting Tool from
“mscalora” on Prusa Printables
It worked great. Check it out.

Prusa

I3 MK3S

No

No

.2

10-20%

I used Tinkercad, Prusa Slicer, and Orca Slicer to make this.
It would be a lot easier to do in Fusion 360 if I knew how to use it, but I don't yet.