I downloaded Mickey Mouse for $5 on this website, but I only wanted the hand so I could make it into one of the pointer finger sticks. I've designes it so that you can slide it onto a bic pen.

Here's the original model: http://www.designsharemake.com/design/mickey-mouse

Wanhao Duplicator i3 V2.1

Doesn't Matter

Yes

0.2 mm

20%

Printed in Wanhao black PLA
Temp: 215 C
Bed: 60 C
Print time: Around 1.5 hours
Slicer: Simplify3d

NOTE: Support material is not necessary in the hole on the bottom. Simplify3D and Craftware offer customizable support, but if you don't have those, i've included the supports from S3D in the files.