Summary

This is a DIY LED Ring for water cooling reservoirs.

Compatibility:

It is designed for standard 60mm diameter water tanks with any height.
For example it fits onto the Alphacool Eisbecher (pictures) or the EK Waterblocks RES X3.

What you will need:

• LED Strip
• PLA/ABS/PETG
• Soldering iron
• LED connector or molex connector

Instruction:

Just print it in the color of your choice, cut a LED Strip into 100mm (in most cases one segment) and solder wires on to it. Then connect the soldered wires to the correct RGB hub or, like I did, just attach it to a 12v cable from the power supply (molex, only one color).

[Do research on the correct wiring - I'm not responsible for accidents]

The LED strip with its clear rubber coating will clamp onto the tube and will not move. It will also not scratch your reservoir, because the printed part doesn't touch it directly, if done correctly.