My friend and coworker just had his second child. I was looking for gift to make them when I stumbled upon this. I added threads to attach all the pieces tightly together. It can only go together one way (threads are different sizes). I also added a little flair on the pommel.

I also added a hole to drop the "peas" into where the handle screws on to the base of the head. This makes it a lot easier to get the "peas" in.

I used tree supports. DO NOT let the supports hold up the roof of the hollow head. This will cause blockage in the hollow head and not allow the rattle to work properly.

For best results use tree supports on all 3 of the main parts. Print the handle standing upright with tree supports on (larger end down). USE 30% INFILL ON THE HANDLE OR THERE IS A CHANCE IT COULD BREAK UPON ASSEMBLY!!!

DISCLAIMER THERE IS A CHANCE THE HANDLE CAN BREAK OFF OR COME UNSCREWED ALLOWING SOME "PEAS" TO ESCAPE. I RECOMEND SUPER GLUING OR PLASTIC WELDING THE MAIN PIECES TOGETHER!!!

ELEGOO

ELEGOO NEPTUNE 3

No

Yes

30% on the handle and 15 for the rest

It took me a few prints to get it right. I always love feedback!