This is a mount for a Wansview IP Camera onto the front of the FlashForge Creator Pro 3D Printer. It is hinged to move out of the way to open the front door. It has a ratchet mount to adjust the angle, so as t reduce glare and give you a better view of the build plate. The Front Bracket It is designed for the best print orientation. The CP_Camera_Holder need to be oriented as shown in the photos of my slicer screen. Printed at .1mm, it is a very long print, but comes out very nice. When Drilling the printer, be mindful of what is on the other side of the holes. Mine was clear, yours may not be.
Extras you need to finish this are:
1- M6 x 25 Hex Bolt
1 - M6 Wing Nut
5 - M4x 15 Hex Bolts
10 - M4 Washers
5 - M4 nuts

I can print this for you. Just use the Treatstock app and select PSD Printing Service. or you can go to my website and use the Treatstock widget. http://www.psdcomputing.com/3d-printing-services

FlashForge

Creator Pro

No

Yes

.1mm

100%

This is best printed in ABS for strength.

Use a small file to file between the hinges. It is supposed to be a tight fit, so the camera will stay in the up position while opening the door