This build turns an Erlenmeyer flask into a separation funnel.

When it's done, it should be possible to extract the different layers of the yeast cake into individual flasks.

It is in the stage of prototyping, and I need to learn beer yeast washing as I go along.
Any comment/suggestions are more than welcome !

RepRap

Doesn't Matter

Doesn't Matter

You want to print the insert single walled so that it breaks away easily, but make sure it is closed, so that the silicone does not flow in.

The clamp must be 100% infill to be strong enough.

Before you print it all, print the template and see if it fits on top of your Erlenmeyer flask, it should stretch a bit when put it on.