Summary

I did not like the restricted air flow on the heatsink nor the 25mm fan mount. I replaced it with a 40mm fan mount and increase the area of flow for the fan. I also switched out the tips for the filament fans and spaced them further apart, this gives room for the wiring from the heater and thermistor.

Print Settings

Printer:

Custom DIY Kossel Mini

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>30</p></div></p>

Источник модели

Оригинальная ссылка: Посмотреть детали

CC BY

Summary

Print Settings

Теги

Источник модели

Похожие рекомендации