Insta360 x3 Loop Mount
module_valley
Найти похожую с ИИ
Профиль печати(0)
Файл модели(0)
0
0
0
Опубликовано:2026-01-15 09:16:23
0
0
000Описание
Источник модели
Отзывы(0)
- Sliced with CURA.
- Print with 100% infill.
- Print with support at 36 degrees. Screw may need some light cleanup, but screwing it in the camera should re-tap it.
- Recommended to print with a brim.
-
Takes about 30mins to print with my slow settings.
- Not tested with PLA, but should work fine.
Источник модели
Оригинальная ссылка: Посмотреть детали
CC BY