Summary

I have printed this in PLA and PETG. Both seem strong enough, just use 100% infil. A peg broke off my old shields and I designed this to replace it. I used a dremel to open a small hole where the broken peg was and glued this replacement in with 5 minute epoxy.

Print Settings

Printer Brand:

Creality

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Ender-3 S1 Pro</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>100</p></div></p>                                                    <strong>Filament:</strong> Overture Any                Any

Источник модели

Оригинальная ссылка: Посмотреть детали

CC BY

Summary

Print Settings

Теги

Источник модели

Похожие рекомендации