Summary

Print Settings

Printer Brand:

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Ender 3 Pro</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>100</p></div></p>                                                    <strong>Filament:</strong> BasicFil PLA                Red                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>All walls are 1.2 mm thick so I printed it with 3 vertical shells. I did use a small brim though I'm not sure its needed. I didn't use any support though the underside of the spout was a little rough once it got past the top of the container height so I think it was printing each layer a bit quick - I think increasing the minimum layer time a little may have helped.</p></div>