Summary

This is a super-quick, simple gift box corner bracket that I created for someone on Facebook that was looking to hold up the corners of a gift box to make it a little taller. Created in Tinkercad in about 5 minutes (as someone who's only used Tinkercad to make things a couple times), it stands about 4.5 inches (115mm) tall, and the user glued them into the base of the box to secure in place.

You'll probably need four of them for a gift box, but remember to lay it down so that you don't need supports, and it should work fine.

Print Settings

Printer Brand:

Creality

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Ender 3 Pro</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>25%</p></div></p>                                                    <strong>Filament:</strong> N/A PLA                Black

Источник модели

Оригинальная ссылка: Посмотреть детали

CC BY

Summary

Print Settings

Теги

Источник модели

Похожие рекомендации