Skeleton Warrior
Rynil0s
Найти похожую с ИИ
Профиль печати(0)
Файл модели(0)
0
0
0
Опубликовано:2026-07-04 06:53:30
0
0
000Описание
Теги
Источник модели
Отзывы(0)
A menacing skeletal warrior clad in jagged armor, wielding a massive sword and shield. The figure stands in a battle-ready stance atop a textured base, exuding a dark and intimidating presence.
Creality Ender 3 V3
FDM Printer
Layer Height: 0.08–0.12 mm (fine detail for minis)
Nozzle: 0.2–0.4 mm (smaller is better for detail)
Infill: 15–20% (higher if you want durability)
Perimeters/Walls: 3–4 walls for strength
Supports: Tree
Print Speed: 30–40 mm/s for accuracy
Material: PLA for easy printing, PETG/ABS for more strength
Nozzle: 0.2–0.4 mm (smaller is better for detail)
Infill: 15–20% (higher if you want durability)
Perimeters/Walls: 3–4 walls for strength
Supports: Tree
Print Speed: 30–40 mm/s for accuracy
Material: PLA for easy printing, PETG/ABS for more strength
RESIN PRINTER (Best for miniatures)
Layer Height: 0.02–0.05 mm (20–50 microns) for best detail
Exposure Time: Depends on resin & printer, usually 2–3s per layer
Bottom Layers: 6–8 with longer exposure (30–50s each) for adhesion
Supports: Use medium supports under arms, sword tip, and shield edges (to prevent warping/failure)
Orientation: Tilt model 30–45° to reduce suction forces and improve detail
Wash & Cure: IPA wash + proper UV cure for durability
✅ Resin will capture the armor, skull, and texture detail perfectly.
Layer Height: 0.02–0.05 mm (20–50 microns) for best detail
Exposure Time: Depends on resin & printer, usually 2–3s per layer
Bottom Layers: 6–8 with longer exposure (30–50s each) for adhesion
Supports: Use medium supports under arms, sword tip, and shield edges (to prevent warping/failure)
Orientation: Tilt model 30–45° to reduce suction forces and improve detail
Wash & Cure: IPA wash + proper UV cure for durability
✅ Resin will capture the armor, skull, and texture detail perfectly.
Теги
Источник модели
Оригинальная ссылка: Посмотреть детали
CC BY-SA