Door Stopper
RusticTundra
Найти похожую с ИИ
Профиль печати(0)
Файл модели(0)
0
0
0
Опубликовано:2026-08-22 01:17:53
0
0
000Описание
Теги
Источник модели
Отзывы(0)
Most of my models, including this one, are released under CC BY-SA 4.0, allowing free use and remix by other creators.
Thank you so much, and I hope you enjoy my works!
About
Door stopper for stopping doors from closing. This is a very simple design, for when you don't want or need anything complicated.
Print Feedback
No supports needed. Depending on your door, recommend printing a high strength print with thick walls and infill, and using PETG over PLA. I also recommend adding an anti-slip strip to the bottom, but may work without it, depending on the floor surface.
Теги
Источник модели
Оригинальная ссылка: Посмотреть детали
CC BY-SA