DoorStop for Vasemode

You can probably print this in less than 30 min on your own printer.

The model is a simple closed surface designed to be printed in vasemode.
I printed it with 0.2 mm layer height and 1 mm line width, using the Archne wall generator.
No top and bottom layers (0 layers), no-brim, no raft and of cause vase mode (spiral vase).
It prints fast and only uses ~14 g of filament.

You can print with a different line line width if you like a little larger or smaller than 1 mm should not make much of a difference.

The doorstop acts like a spring and needs to deform a little to hold the door. I printed it in PETG, it has relatively low friction with the floor, so it cannot hold a heavy door. But it has no problem holding my doors.