This is a light box based on the WWF Attitude logo. It will perfectly match any wrestling collection. Any wrestling fan will love it.

I've already added a hole on the side of the front panel. If you don't need it, you can delete it.

Bambu Studio

Please follow my configuration, and everything will go well. Of course, you can also make changes as you like. Here are my settings:

Printing plate type- Textured PEI printing board

Quality- Elephant Foot Compensation - 0

Quality- Arachne - Default settings

Intensity- Number of layers in the bottom shell - 5

Intensity- Internal solid-filled pattern - monotonous

Intensity- Sparse filling density - 5%

Intensity- Sparse filling pattern - Gyroid

Speed- Initial layer - 25 mm/second

Speed- Initial layer filling - 50 mm/second

Other- Brim type - without a brim

Other- Brim width - 1

Assemble the light box

I tend to use aluminum foil tape as a backing board, which can better reflect light. I use strong glue and activator spray, but I'm very careful to control the amount of glue. If there's too much, it will overflow the edges and leave white marks when it dries. I usually use these LED strips for the light boxes I make.5V USB LED strip light SMD 2835, 50CM, 1M, 2M, 4M, 5M, white/warm white/red/blue/green, IP21, flexible lighting strip for backlighting - AliExpress 39When installing the light strips, try to keep them in the middle of the wall. If they are too far back, it will hinder the adhesion of the back panel, and if they are too far forward, the lighting effect won't be as good.

If you have any questions, please leave a message for me.