Hi all,
I made custom library files for Solidworks to have the possiblity to use the gas tap & die in the thread function. The common sizes are added not all specific and rare ones.

Be sure to save them in the right folder. There you'll find the original ones (metric, inch, etc..)

Note:
Die:
1) If you'll make a die, look at the size chart to have the correct external diameter.
Tap:
1) use the hole wizard (gas) the holes are thinked drill (not theoretical). Practical to have directly a mounting gap.
2) If you sketch the hole, you can also look at the chart. I noted the drilling sizes.

About the chart, the other dimensions are indicative if you want to have a look to the dimensions

PS: I was not allowed to use a slash in the denomination. So I used a dash (ex: 1/8 = 1-8)

Hope it will be usefull for someone. Never understand why Solidworks never added these in the thread function.