Print with a layer height of 0.08 mm and a base height of 0.16 mm, and fill the model with 100% infill.

The model size is 200x200mm.

You can print with a higher layer height at a minimum depth of less than 0.72mm.

The maximum depth is 1.8mm, and the actual depth is also 1.8mm.

Consumables used:
PLA+ Numakers, black. Transmission distance: 0.3
PLA+ Numakers Royal Blue. Transmission distance: 3.2
PLA+ Numakers core red. Transmission distance: 4.8
PLA+ Numakers grass green. Transmission distance: 4
This print uses four unique consumables.

Switching command:
Start printing from black
Switch to royal blue on the 10th layer
Switch to the core red on the 11th layer
Switch to grass green for the remaining part on the 12th layer