A dock / holder for the Olight Arkpro series of flashlights. Magnetic charger snaps into bottom cavity in charger. The charger should remain loose but captured while snapped into place and the cable can be directed up / down / left / right as desired. To remove charger push up from the bottom of the dock.

Designed to have magnets glued into the back (0.25" x 0.125" Neodymium Disc Magnets). 

Magnets used: https://www.amazon.com/dp/B0DJVGM6F2?ref=ppx_yo2ov_dt_b_fed_asin_title

Superglue used: https://www.amazon.com/dp/B00C32MHJU?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

Compatible lights (I have personally checked): Arkpro Ultra, Arkpro, Arkpro Lite, Arkfeld Ultra

I may rev this design with use, open to recommendations or requests.

V9 - Designed to address the surface slip present on the V8. Requires 11 magnets. Adding something tacky to the surface may help address the slippage, but I feel like it's function now is sufficient. The angle from mounted surface was reduced to about 16.25 degrees.

V8 - Designed for 6 magnets, kind of slides around due to the strength of the magnet in the charger. Is sufficient to hold the light without the charger installed, but V9 was designed to attempt to address this problem. Angles the light at about 22.5 degrees away from the mounted surface.