A snarling gargoyle head on a 62 mm round backplate — mounts flat on

a wall and serves as a hook. The face protrudes ~25 mm from the

wall; drape a hand towel, dish rag, keys on a lanyard, a face mask,

or any small item over the head and it stays put.

Two versions in the bundle:

• gargoyle_hook.stl — backplate with two M4 screw thru-holes for

•   drywall / sheetrock mounting

• - gargoyle_hook_plain.stl — backplate without holes, for glue-only

•   or 3M-strip mounting on tile / glass / painted surfaces

Print notes:

• Disk-flat-on-bed orientation, gargoyle face pointing UP during print

• - 0.2 mm layer, 15–20 % infill is plenty (it's mostly decorative)

• - No supports needed — the floor_clip trim makes any deep-embedded

•   back-of-head geometry get cut flat by the bed

• - ~60 mm wide × ~40 mm tall (gargoyle) × ~30 mm deep total

• - PLA / PETG both fine; matte black or stone-grey filament looks most

•   gargoyle-like

Mount with two short drywall screws (M4 or #6) on the with-holes

version, or four small 3M-style adhesive squares around the disk

back on the plain version.